Product ID:FORMULA 596 CONCRETE SEALER, PART A
MSDS Date:09/01/1991
FSC:8040
NIIN:00N078495
Kit Part:Y
MSDS Number: CGGJH

STATE CHEMICAL MFG CO

3100 HAMILTON AVE
CLEVELAND, OH 44114-3783
US

Emergency Phone: 216-861-7114

Info Phone: 216-861-7114

Cage: 53798

STATE CHEMICAL MANUFACTURING CO.

CLEVELAND, OH 44114-3701 US

Telephone: 216-861-7114

Cage: 53798

BISPHENOL A-EPICHLOROHYDRIN COPOLYMER

CAS: 25068-38-6

RTECS: SL6475000

Fraction By Weight: <25%

OSHA PEL N/K

ACGIH TLV: N/K

MODIFYING AGENT; (REACTIVE MODIFIER)

Fraction By Weight: <3%

OSHA PEL N/K

ACGIH TLV: N/K

2-PENTANONE, 4-HYDROXY-4-METHYL-; (DIACETONE ALCOHOL)

CAS: 123-42-2

RTECS: SA9100000

Fraction By Weight: <2%

OSHA PEL 50 PPM

ACGIH TLV: 50 PPM

ETHANOL, 2-PROPOXY-; (ETHYLENE GLYCOL MONOPROPYL ETHER)

CAS: 2807-30-9

RTECS: KM2800000

Fraction By Weight: <4%

OSHA PEL N/K

ACGIH TLV: N/K

<260 GM/LITER

RTECS: 9999999VO

OSHA PEL N/K

ACGIH TLV: N/K

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:ACUTE:DIRECT CONTACT WITH EYES CAUSES
IRRITATION. PROLONGED BREATHING OF VAPORS MAY CAUSE HEADACHES,
DIZZINESS, AND RESPIRATORY IRRITATION. HARMFUL IF SWALLOWED. MAY
IRRITATE SKIN/CAUSE REDDENING & SW ELL. ETHYLENE GLYCOL
MONOPROPYLETHER MAY CAUSE BLOOD DISORDERS WHEN INGESTED (BASED ON
ANIMAL DATA). (EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT.
Effects of Overexposure:HLTH HAZ:CHRONIC:MAY AFFECT LIVER, KIDNEYS,
CENTRAL NERVOUS SYSTEM, BONE MARROW, AND BLOOD CELLS, AFTER
REPEATED OVER EXPOSURE. REPEATED SKIN CONTACT WITH EPOXY RESIN MAY
CAUSE SENSITIZATION WITH DEVE LOPMENT OF ALLERGIC SKIN REACTIONS.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

First Aid:INGEST:CALL PHYS IMMED. DO NOT INDUCE VOMIT. INHAL:AVOID
PRLNGD BRTHG OF VAPS. REMOVE PERSON TO FRESH AIR. IF IRRIT/DFCLTY
IN BRTHG PERSISTS CONT PHYS. EYE:FLUSH IMMED W/PLENTY OF COOL WATER
FOR @ LST 15 MINS. IF IRRIT PERSISTS, SEEK MED ATTN. SKIN:WASH
THOROUGHLY W/PLENTY OF SOAP & WATER IF IRRIT DEVELOPS, CONT PHYS.
SOLVS SHOULD NOT BE USED TO CLEAN SKIN BECAUSE OF INCREASED
PENETRATION POTNTL.

Flash Point Method:TCC
Flash Point:142F,61C
Extinguishing Media:CARBON DIOXIDE, DRY CHEMICAL, ALCOHOL FOAM OR WATER
SPRAY.
Fire Fighting Procedures:USE NIOSH APPROVED SCBA & FULL PROTECTIVE
EQUIPMENT . AVOID STREAM OF WATER TO CONTROL FIRES SINCE FROTHING
CAN OCCUR.
Unusual Fire/Explosion Hazard:REMOVE ALL IGNITION SOURCES. HIGH TEMPS &
FIRE CNDTNS MAY CAUSE RAPID & UNCONTROLLED POLYMERIZATION WHICH CAN
RSLT IN EXPLOSIONS & VIOLENT RUPTURE OF CNTNRS.

Spill Release Procedures:ELIMINATE IGNITION SOURCES. ABSORB WITH INERT
MATERIAL AND FLUSH AREA WITH WATER. PREVENT WASHING FROM ENTERING
WATERWAYS.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:DO NOT STORE AT TEMPERATURES ABOVE
120F OR EXPOSE TO SUNLIGHT. KEEP FROM HEAT, SPARKS, AND OPEN FLAME.
AVOID CONACT WITH SKIN AND EYES.
Other Precautions:READ & FOLLOW ALL LABEL DIRECTIONS & PRECAUTIONS
BEFORE USING PRODUCT. THESE PRODUCTS ARE INTENDED FOR INDUSTRIAL &
INSTITUTIONAL USE ONLY. NOT FOR HOUSEHOLD USE OR RESALE. KEEP OUT
OF REACH OF CHILDR EN.

Respiratory Protection:NIOSH APPROVED RESPIRATOR SHOULD BE USED IF TLV
WILL BE EXCEEDED.
Ventilation:ADEQUATE VENTILATION IS REQUIRED.
Protective Gloves:NEOPRENE GLOVES.
Eye Protection:ANSI APPRVD CHEM WORKERS GOGGLES .
Other Protective Equipment:ANSI APPRVD EYE WASH & DELUGE SHOWER .
Work Hygienic Practices:WASH SKIN THOROUGHLY WITH SOAP AND WATER AFTER
HANDLING.
Supplemental Safety and Health
MATLS TO AVOID:OR MERCAPTANS. STRONG ACIDS, EPOXIES AND ISOCYANANTES
ADDED TO PART B MAY CAUSE POLYMERIZATION.

Spec Gravity:1.04 (WATER =1)
pH:7-9
Evaporation Rate & Reference:NOT KNOWN
Solubility in Water:SOL BEFORE CURING
Appearance and Odor:A MILKY WHITE EMULSION WITH A SLIGHT SOLVENT ODOR.

Stability Indicator/Materials to Avoid:YES
POLYMERIZATION INITIATORS INCLUDING PEROXIDES, STRONG OXIDIZING AGENTS,
STRONG ACIDS, STRONG BASES, AMINES, (SUPDAT)
Stability Condition to Avoid:HEAT, SPARKS AND OPEN FLAME. DO NOT EXPOSE
TO LIGHT OR STORE ABOVE 120F.
Hazardous Decomposition Products:NONE SPECIFIED BY MANUFACTURER.

Waste Disposal Methods:DO NOT REUSE EMPTY CONTAINERS FOR ANY PURPOSE.
FOLLOW ALL FEDERAL, STATE AND LOCAL REGULATIONS REGARDING WASTE
DISPOSAL.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.